Results 1 to 4 of 4

Thread: Playpen help

  1. #1
    Young Bun Amy1989's Avatar
    Join Date
    Nov 2013
    Location
    Bristol
    Posts
    48

    Default Playpen help

    Hey everyone

    I have recently bought one of these http://www.ebay.co.uk/itm/6-or-8-24-...item51ab01839b
    I remember reading quite a few threads about meshing the outside of the pen, can anyone recommend the best material to use? I did try chicken wire but where I had to cut the pieces the ends where really sharp. I want to mesh it as the gaps are quite big, they don't bend but I'm worried about them getting there head stuck. Also the pen is up against the g pigs hutch and they like to chew through to the wood of the hutch.

    Thanks

  2. #2
    Moderator Zoobec's Avatar
    Join Date
    Feb 2013
    Posts
    36,602

    Default

    Weldmesh is stronger than chicken mesh, you can get sharp edges where you cut it (found this out wrestling with a huge roll to mesh the run, managed to gash my hand ) but if you cut it to a whole square I've found it ok.

    Binky free at the bridge Boots, you will never be forgotten xxxx

  3. #3
    Wise Old Thumper little-laura's Avatar
    Join Date
    Jan 2011
    Location
    Nottingham
    Posts
    14,613

    Default

    I'm trying to find the mesh I used as it didn't leave shape edges

    If i find it I'll post it on here

  4. #4
    Young Bun Amy1989's Avatar
    Join Date
    Nov 2013
    Location
    Bristol
    Posts
    48

    Default

    Thanks

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •